This was a quick hat, designed to provide maximum coverage while still fitting quite close to the crown. Having managed to get my hands on some lovely Noro Kureyon sock yarn, only to be dissatisfied with it for socks (it’s not very hard wearing, being a single ply yarn), I thought it would make a lovely hat. A quick stash dive yielded 3 x 100g skeins, however the hat all up used only around 75g – there’s about a quarter of the skein left. I suspect a matching scarf may be in the works. The Noro Kureyon knits up beautifully – my only concern was a tendency to tangle, but in fairness it is a centre-pull skein, which I *was* pulling from the centre!
The band is doubled over and secured to the inside using crochet, then wide elastic is used to help the hat stay in place. This also makes the band seem to be quite dense – which I think adds to the design.
Yarn
75g Noro Kureyon sock yarn, shade S149 Brown/beige pictured
Notions
2.75mm circular needle (for knitting magic loop) or 2.75mm DPNs, 6 x stitch markers, approx 50cm of elastic which is 2-2.5cm wide for threading through band, safety pins, yarn needle, 2.75mm or similar crochet hook for doubling over and securing the band, buttons or other accessories to decorate if desired.
You may need to use a different yarn to get gauge, gauge for finished hat is 30 stitches and 48 rows to 10cm (4 “)
Pattern
- Cast on 9 stitches, join in the round (magic loop or DPN)
- * Knit front and back (kfab). Repeat from * to end (18 stitches) (this is a bit tricky over 4 DPNs, you might want 3 needles then move to 4 when there are more stitches after the increases)
- Place 6 stitch markers evenly through the stitches (every 3 stitches)
- Work for crown of head by * knitting to stitch before stitch marker, kfab, slip stitch marker from left to right needle, kfab*, repeat from *, knit to end of row. Essentially, you are increasing 12 stitches on each round.
- Repeat this pattern 41 times more until you have 270 stitches.
- Leaving the stitch markers in, work 20 rows without increasing (270 stitches)
- Decrease 12 stitches in each of the next 8 rows as follows: *knitting to two stitches before stitch marker, knit 2 together (k2tog), slip stitch marker from left to right needle, k2tog*, repeat from *, knit to end of row.
- You should now have 174 stitches.
- Work 24 rows of 1 x 1 rib (knit 1, purl 1), case off loosely.
- Fold the ribbed band over from the right side of work to wrong side of work, essentially doubling the band over. Using crochet hook and slip stitch (or stitch of your choice – you could sew if preferred), affix cast off edge of band to wrong side of work. Leave about 2.5cm (1″) unaffixed (for threading through elastic)
- Measure elastic to desired fit and cut. Using safety pins, thread elastic through doubled over band and sew elastic together.
- Sew in any loose ends, in particular the cast on (9 stitches) will need to be closed over properly.
- Press or block if desired.

